Britannia Rails SAKO 75/85 Ultralow Aluminium Standard Picatinny Rail - Action 4/LA - 2-0063

Your Price: £104.99
In Stock.
Part Number:2-0063

Our SAKO 75/85 rails are made to fit over Optilock Bases, giving a secure fit. Available in either a vapour blasted finish or hard anodised black.

Action                  Calibres

Action 1/XS         .222 & .223

Action 3/S           22-250 Rem, 243 Win, 260 Rem, 7mm-08 Rem, 308 Win

Action 4/LA         .270 Win, 30-06 SPRG, 6.5x55, 7x64, 8x57IS, 9.6x62, 9.3x66

 

Material: 6061-T6 Aluminium

Finish: Hard Anodised or Vapour Blasted

Fitting: Fits over Optilock Bases

MOA: 0

Length: 155mm

 

Fitting instructions for Sako 75/85 picatinny Rails

Warrning

· Attention always ensure that firearm is unloaded

· Bolt is removed

· All normal safety precautions are followed

· This is an ultralow picatinny rail, which is designed to be an interference fit

· Whilst doing this pay particular care not to damage either the rail or the rifle with any tool used.

 

Step 1

Ensure bolt is removed from rifle

 

Step 2

Remove all screws from rail before fitting

 

Step 3

Slide rail onto dovetails from rear

 

Step 4

With a suitable tool (Soft faced hammer) tap the rear of the rail onto the dovetail until the bottom for the rear face of the rail is as far forward as the rear most edge of the rear dovetail.

Rember this rail is an interference/friction fit and tolerances on the dovetails of the Sako rifle can be quite varied so some many require more percussion effort than others.

 

Step 5

Fit the rear most (Large screw) which acts as a recoil lug and ensure that it goes down all the way through, until it is visible from the rear, under the rail and in contact with the rifle action below.

If you have pushed the rail too far onto the dovetail, you may need to tap the rail gently rearward until the recoil screw can be fully seated, as above.

 

Step 6

Remove recoil lug screw and treat all five grub screws with the Vibra-tite provided and screw home with the allen keys provided long end into the screw head, short end for turning i.e ? . This screws only need to be nipped tight.

 

Step 7

Whilst ensuring rifle is unloaded and in a safe direction, refit, and cycle bolt to ensure clearance of the back of the rifle.

 

Use

Due to the ultralow nature of this rail and the extraction system on Sako rifles, it is advised to eject cases using a smooth fluid motion when cycling the bolt.

 

If you have any doubts or concerns when attempting to fit this rail please consult a qualified gunsmith.


Related Items

Recently Viewed Items