Bore Tech’s Patented Shotgun Patch Jags are a must have for
every serious shotgunner. These durable nylon jags make shotgun cleaning a
breeze thanks to the 4 flexible petals that grip patches allowing them to
perfectly conform to the barrel surface. Engineered for superior cleaning and
functionality these one of a kind jags even have the ability to compress and
pass through choke tubes.
Bore Tech’s Patented Shotgun Patch Jags set the benchmark
for quick and effective shotgun cleaning and are a must have for every
Bore Tech Shotgun Patch Jags provide 360 degrees of
concentric pressure against the barrel’s surface resulting more patch contact,
better cleaning and a perfect fit every time. This is accomplished by the 4
oversized, flexible petals that compress when entering the bore, providing
outward pressure which allows the patch to perfectly conform to the barrel
surface. Incorporated into each of the 4 flexible petals are gripping rings
which securely grab the patch preventing bunching.
Quick and effective, these jags can be used between stages
or at home. Simply spike your patch and down the barrel you go. No need to
worry about fixed or removable choke tubes as the Shotgun Patch Jags have the
ability to compress and pass through any choke tube!
Now that’s shotgun cleaning made quick and easy.
Bore Tech Shotgun Patch Jags are available from 10 - 410
gauge and fit any standard shotgun rod with 5/16-27 threads.
Bore Tech - Redefining Gun Care
Proudly made in the USA
Shotgun Patch Jags
Threads: 5/16 – 27
Overall Length ( Including Point ): 2.5 inches
Shotgun Jag Instructions:
Screw the Bore Tech Shotgun Jag onto the cleaning rod.
Spike a patch over the spear point attempting to pierce the
patch near the center. (See Figure 1).
Apply cleaning solvent until patch is saturated.
Insert Jag into breach end of the barrel and slowly push
through entire length of the barrel.
NOTE: When resistance is encountered near the end of the
barrel due to the reduced diameter of a choke, begin rotating the rod in a
clockwise direction while applying a slight forward pressure. This allows you
to ease the jag through the restricted choke area. (See Figure 2)
Next, thoroughly brush the barrel with cleaning solvent to
loosen fouling that has adhered to the barrel walls.
Finally, using a clean dry patch insert the Shotgun Jag into
breach end of the barrel and slowly push through entire length of the barrel.
Repeat the process as necessary until patches come out clean.
Q: Will these jags fit my old shotgun rod?
A: Our Shotgun Jags have male 5/16-27 threads and will fit
most current brand shotgun rods.