Bore Tech’s RIMFIRE, BOLT ACTION BORE GUIDES precisely
align cleaning rods with the rifle bore and prevent damage to both the firearm
and cleaning rod, making it a necessary tool for proper cleaning and
protection.
The Bore Tech Rimfire Bore Guides are CNC machined from a
rugged, solvent-resistant, synthetic polymer that perfectly aligns cleaning
rods with the bore and prevents cleaning rods from dragging along the ejector.
This eliminates scratching of your cleaning rod and wear on the ejector. Each
Bore Tech rimfire bore guide is designed to seat against the rear of the
barrel/chamber and minimizes cleaners from leaking into the action. Featuring a
tapered rear opening for easy jag/brush alignment and a widened solvent port
for easy solvent application these guides will provide a lifetime of use.
All Rimfire Bore Guides are custom-made specific to the
rifle model/action. This ensures a precise fit and avoids interference from
ejectors, trigger sears, and bolt releases.
Bore Tech stocks Bore Guides to fit most popular .17 and .22
caliber Rimfire, bolt action rifles. Please contact Customer Service to inquire
about custom-made Rimfire Bore Guides.
Bore Tech - Redefining Gun Care
Proudly made in the USA
RIMFIRE BORE GUIDE
Bore Tech Rimfire Bore Guide Length: 10.5 Inches
Bore Tech Rimfire Bore Guides will add approximately 10.5
inches to the length of the barrel when cleaning. Make sure your cleaning rod
is long enough to accommodate.
How To Determine The Correct Rod Length For Your Application
Bore Tech Rimfire Bore Guide Use Instructions
1) Remove bolt as per manufacturer’s instructions.
2) Insert Bore Guide through the receiver until seated
against the base of the chamber.
3) Position a dry patch of the proper size on a jag and insert the rod/jag into
the rear opening of the bore guide until visible in the solvent port.
4) Apply cleaner or oil to the patch and push through the
bore.
5) The solvent port may also be used to apply cleaner to
brushes.
6) To remove the Bore Guide from the action, pull the guide
back away from the chamber and out of the action.
NOTE: For Rimfire actions with exposed bolt
releases/sears it may be necessary to pull the trigger while attempting to
remove the guide. This releases the pressure against the guide allowing it to
be easily removed.
FAQ
Q: Will these Bore Guides work on centerfire rifles?
A: No, these guides only fit specific rimfire, bolt action
rifles. Please see our Centerfire Bore Guides for this application.
Q: What length rod do I need to use with this Bore Guide?
A: Please see our Knowledge Center for assistance in
determining the proper rod length for your application.
Q: How long are the Bore Guides?
A: The Rimfire Bore Guides are approximately 10.5 inches in
length.
